You have to be logged to request access.
You have to be logged in to proceed.
Copy & paste the following URL to share this project:
Copy & paste the following numbers into/from another project to mimic the viewpoint:
At least one displacement boundary condition is needed. You did not specify any.
Are you sure you want to continue without a displacement boundary condition?
You might add a new BC now with the magenta button below. Afterward, just select at least
one face (it will be painted magenta) and you will be ok to move to the next step.
At least one boundary condition was added but no faces where it should be applied to were defined.
You might want to “paint” at least one surface for each boundary condition. Are you sure you want to continue?